Kyosho Fazer Mk2 FZ02 Center Drive Shaft Upgrade JR-KFZ200-RD by Jazrider  [JR-KFZ200-RD]

Kyosho Fazer Mk2 FZ02 Aluminum Main Center Shaft (Red)
Price:
AUD$5.43
Brand:
JAZRIDER
Model:
JR-KFZ200-RD
Condition:
Brand New
Available in shop
Write a review

Lightweight Aluminium Center Axle

Intended for the Kyosho Fazer Mk2 FZ02 chassis, this centre shaft is an aluminium replacement listed as model JR-KFZ200-RD. The component shows a red finish and is manufactured to fit into the Fazer Mk2 FZ02 centre drive assembly.

Performance note: the shaft forms the spine of the on-road drivetrain, carrying gears and bearings and affecting alignment and chassis stiffness. Upgrading to an aluminium axle reduces unwanted flex and supports precise suspension and handling setup work.

Fitment guidance: replacing the centre shaft requires careful disassembly of the Fazer Mk2 FZ02 centre section, removal of the factory shaft and reinstallation with correct bearing seating and gear mesh checks. Use the correct hex tools and refresh any worn bearings or retainers during service.

Compatibility: this item is designated for the Kyosho Fazer Mk2 FZ02 platform and intended for on-road RC use only.

Does the shaft affect chassis stiffness?

Yes; swapping the stock shaft for an aluminium unit like JR-KFZ200-RD reduces drivetrain compliance and can increase perceived chassis stiffness, which influences handling balance.

Should I check anything after fitting?

After installation, confirm that bearings are fully seated, that gear mesh is correct, and perform a final spin test to ensure there is no binding before track use.

Will this work with the original centre housings?

The shaft is designed to work with standard Fazer Mk2 FZ02 housings and bearings when dimensions match; replace worn housings or bearings if fit is loose or noisy.

Copyright © 2008-2026 rcjaz.com.au All rights reserved