Kyosho FW-06 Alloy One Way Hub Performance Part FW06-09 by 3Racing  [FW06-09]

FW-06 alloy one way hub for tighter drive

This aftermarket aluminium one way hub is made to replace the stock hub on Kyosho FW-06 chassis and provide a firmer mechanical link between wheel hub and diff assembly. The firmer interface influences torque transfer on acceleration and during corner exit, producing a more direct throttle response.

Installation is straightforward and follows the same steps as the stock hub swap: remove the original, fit the aluminium hub, confirm correct seating and thread engagement, and ensure clearance around nearby suspension and steering parts. Typical hex drivers and wheel nut tools are all that is required; consult your chassis guide for torque specs.

On-track tuning: an aluminium hub increases stiffness and may change traction behaviour. Incorporate diff preload adjustments, slipper/clutch setting changes, and ESC braking tuning to match the new drivetrain character. Watch for any signs of accelerated wear at hub contact points and re-check fasteners after the initial outings.

Best used as a tuning upgrade within a complete drivetrain setup, this aluminium hub suits FW-06 on-road cars where firmer hub engagement is desired.