Kyosho FW-06 Graphite Front Brace Plate FW06-04 by 3Racing  [FW06-04]

Kyosho FW-06 Graphite Upper Bumper Plate - 3RACING FW06-04
Price:
AUD$15.87
Brand:
3Racing
Model:
FW06-04
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Graphite front brace plate

This graphite upper bumper plate serves as a direct-fit replacement for the Kyosho FW-06 chassis, listed as FW06-04. The graphite element reduces unwanted flex at the forward mounting area while retaining the stock hole pattern for straightforward installation.

Installation is simple: remove the original upper bumper plate, align the graphite plate with the FW-06 mounting points and refit with the existing fasteners. Standard hex drivers are sufficient and the part is designed to reuse the original hardware and mounting locations.

From a setup point of view the plate increases local stiffness around the bumper mounts, helping to keep shock and bumper alignment more consistent after small impacts and during tuning changes. Material selection focuses on dimensional stability without altering chassis geometry.

Does this require drilling or trimming?

No drilling or trimming is normally required when fitting to a standard FW-06 chassis because the plate matches the factory mounting layout.

Will the plate work with stock bumpers?

Yes, the plate is intended to be used with the stock bumper assembly and to reuse the original fasteners and positions.

Is there a noticeable performance gain?

Performance gains are subtle and focused on setup consistency and repeatable mounting alignment rather than dramatic handling changes.

Copyright © 2008-2026 rcjaz.com.au All rights reserved