Kyosho IF613HB-01B Rear Hub Carrier Bush Set for MP10  [KY-IF613HB-01B]

Replacement bush set for MP10 rear carriers

The rear hub carrier bush set is an RC-scale replacement tailored for the Kyosho MP10 chassis to restore proper lateral clearance and rotational alignment at the rear hub carriers. The components address the hub-to-carrier interface rather than bearings or drive items and are fitted when bushings have worn and begin to compromise handling and suspension geometry.

Installing these parts is direct if you have experience removing rear hubs: remove the wheel and hub assembly, push out the worn bushings, gently press or tap the new bushings into the carrier with care, then refit using the existing hardware. Double-check axle alignment and ensure free rotation before final tightening to prevent binding.

When tuning, these bushings help stabilise toe and camber under load by eliminating excess play at the pivot, which is helpful during suspension setup or after hard track use. Regularly clean mating surfaces and adjacent ball bearings and inspect for wear to keep handling consistent and extend component life.