Kyosho Mini Inferno Front Steering Knuckle MIF021 by GPM  [MIF021]

Front steering knuckle arm for Mini Inferno

This alloy front knuckle arm is an aftermarket replacement produced for Kyosho Mini Inferno ST and Mini Inferno chassis. It is supplied as a straightforward upgrade to the stock steering knuckle while preserving the original mounting points to mate with Kyosho steering hardware.

Made from machined alloy to minimise steering linkage flex, the arm helps preserve alignment under load. The part is focused on the front knuckle position for 1/10 scale buggies running the Mini Inferno platform, for both electric and nitro powertrains.

Installation advice: verify existing screws, ball bearings and retaining pins, transfer any necessary washers or pins from the original piece, and tighten hex screws to the correct torque without over-stressing threads. Confirm toe and ackerman adjustments after installation to maintain desired handling.

Tuning advantages: an alloy knuckle arm stiffens the steering pivot and reduces unwanted compliance, which supports more consistent steering feedback when you fine tune caster, toe or link geometry.