Kyosho Mini Inferno Front Swing Shaft Upgrade MIF-021/BU by 3Racing  [MIF-021/BU]

Kyosho Mini Inferno Front Swing Shaft( 1 pairs ) Half8 - 3RACING MIF-021/BU
Price:
AUD$16.03
Brand:
3Racing
Model:
MIF-021/BU
Condition:
Brand New
Write a review

Replacement front shaft for Mini Inferno

This front swing shaft is made for the Kyosho Mini Inferno chassis and is identified by part MIF-021/BU. It functions as the pivot axle for the front suspension links and replaces worn shafts to restore correct arm movement.

To install, remove the front arms, swap in the new shaft, check that the suspension links rotate freely, and confirm there is no interference with steering linkages. Cycle the suspension through its full travel and recheck all clearances before final trimming or tuning.

The front shaft is a common wear item that affects setup consistency more than peak performance; replacing it helps preserve steering predictability and keeps suspension geometry stable after shock or steering servo changes.

Can this be used on other Kyosho kits?

It is intended for the Mini Inferno layout. Other Kyosho kits may require different shaft lengths or bearing positions, so confirm dimensions before using it elsewhere.

What should I check after fitting?

After fitment, verify suspension freeplay, steering centring, and that links do not rub against the chassis or servo horns. Adjust fastener torque to avoid preload.

How often should I inspect this part?

Inspect the shaft and mating holes during routine maintenance or after crashes; replace if you notice slop, scoring, or uneven wear to keep handling consistent.

Copyright © 2008-2026 rcjaz.com.au All rights reserved