Kyosho Mini Inferno Steering King Pin Holders - Graphite - MIF-024/WO by 3Racing  [MIF-024/WO]

Kyosho Mini Inferno /Kyosho Mini Inferno ST Graphite King Pin Holder Set (2 pcs) - 3Racing MIF-024/WO
Price:
AUD$8.16
Brand:
3Racing
Model:
MIF-024/WO
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Steering king pin holders in graphite

This graphite king pin holder set fits Kyosho Mini Inferno and Mini Inferno ST chassis and is supplied as model MIF-024/WO. The two graphite holders are intended to be a lightweight, low flex replacement that secures the king pin location within the steering assembly.

Compatibility is restricted to the stated Kyosho Mini Inferno variants; no other fitment is implied. Install by replacing the stock holders, which adjusts steering stiffness without modifying primary suspension geometry. The reduced movement at the king pin helps keep steering consistent during tuning and hard runs.

Installation relies on the original knuckle and mounting hardware from the Kyosho chassis. Use this set as a maintenance upgrade or tuning item rather than a structural chassis change.

Does this replace the stock holders?

Yes, these graphite holders are designed to replace the stock king pin holders on the specified Mini Inferno models.

Do I need different screws?

In most cases you can reuse the existing screws and knuckle hardware. Verify thread condition and length before final assembly.

Will handling be noticeably different?

You should feel reduced compliance at the king pin, which helps maintain steering geometry at speed and during cornering, leading to a more predictable response.

Copyright © 2008-2026 rcjaz.com.au All rights reserved