Kyosho V One RRR 22T Service Hardened Second Gear V3R-0822 by 3Racing  [V3R-0822]

Price:
AUD$6.82
Brand:
3Racing
Model:
V3R-0822
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

22T hardened second gear for V One RRR gearboxes

V3R-0822 is a 22-tooth hardened aluminium second gear made for Kyosho V One RRR and V One RRR Evo 1/10 touring car gearboxes. It is provided as a direct replacement using a harder alloy to reduce the rate of tooth wear compared with common soft alloy parts.

Installation is carried out using standard gearbox maintenance steps: open the gearbox, remove the worn second gear and any associated bearings, then press the replacement gear into position with suitable presses or drivers. After fitting, confirm gear mesh, endplay and bearing condition before full-power running.

This component is focused on upkeep and durability rather than ratio changes; fit the hardened 22T when teeth are worn or when a tougher tooth surface is required for sustained, heavy-duty track sessions.

Does this replace the factory second gear directly?

Yes, the part is designed as a direct second gear replacement for Kyosho V One RRR and V One RRR Evo gearboxes, but check shaft and bearing condition during the swap.

Any break-in recommendations?

After assembly, run the gearbox at low throttle for a short period to ensure the new gear seats correctly and to check for noise or binding before pushing hard on track.

Will this stop all gear wear?

Hardened aluminium slows surface wear compared with softer alloys, but correct setup, lubrication and bearing health remain important for overall longevity.

Copyright © 2008-2026 rcjaz.com.au All rights reserved