KYOSHO V One RRR Compatible Titanium Rear Lower Pin V3R-035C by 3Racing  [V3R-035C]

Rear lower suspension pivot pin

This titanium rear lower suspension pin is an aftermarket replacement for the KYOSHO V One RRR line, designed to reduce pivot wear and resist corrosion while keeping added mass to a minimum. It is intended for use where the factory rear lower pivot pin is fitted.

Compatibility statement: the pin fits KYOSHO V One RRR, V One SIII and V One RRR Evo 64 rear lower pivot points as listed. Always confirm your chassis' pivot design matches the part before attempting installation.

Fitting procedure: remove the rear lower link and original pin per your normal servicing steps, check the link bore and bushings for any wear, then install the titanium pin using the existing retaining hardware. Note that titanium has different friction characteristics than steel so check articulation and securement on first run.

Impact on setup: switching to a titanium pivot helps maintain consistent pivot geometry by reducing corrosion and wear at the lower link over time. That consistency supports stable handling when you test changes to suspension or damping settings.

Routine checks: after initial track or park runs inspect for lateral play or surface marks, keep the pivot contact faces clean, and verify retaining clips or screws remain tight. Use threadlock or anti-seize only as directed to prevent contamination.