Kyosho V One RRR Steering Bar V3R-028 Direct Fit by 3Racing  [V3R-028]

Steering Handle Bar for V One RRR

This component is a direct replacement handle bar for Kyosho V One RRR and V One RRR Evo steering systems, aimed at restoring correct steering geometry and tie-rod alignment while keeping the original chassis layout unchanged.

Fitment details: the bar installs in the original steering link location and helps maintain expected steering response for on-road chassis. It is designed as a service or setup part, not as an automatic performance enhancer.

Fitting tips: remove the stock handle bar, confirm link lengths and pivot alignment, then fit the replacement and check for smooth steering movement through the full travel. Correct any binding and adjust toe and steering centring after installation. Use the existing mounting points and check ball seats and bearings as part of the swap.

Setup advice: following replacement, re-check front-end geometry and steering throw. Small changes to link lengths or pickup points will alter turn-in and mid-corner balance, so validate handling with a short run and fine tune progressively.