Kyosho V One RRR Tuning Delrin 59T Spur Gear V3R-0859 by 3Racing  [V3R-0859]

Kyosho V One RRR /V One RRR Evo Low Friction Delrin Super Gear 59 Teeth - 3Racing V3R-0859
Price:
AUD$3.29
Brand:
3Racing
Model:
V3R-0859
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Low-drag 59T Delrin spur

The V3R-0859 Delrin 59-tooth spur is supplied as a replacement for Kyosho V One RRR and V One RRR Evo 1/10 electric touring car drivetrains. Its Delrin construction aims to reduce internal gearbox friction and provide reliable contact between pinion and spur.

Fitting is simple for those familiar with touring car layouts: remove the chassis top or gear cover, swap the factory spur for the Delrin 59T, then set the pinion mesh. Reuse the original mounting hardware and rotate the drivetrain manually to ensure there is no tightness before powering the motor. Small mesh and shim tweaks will help cut noise and wear.

As a setup part, this spur is intended to refine driveline efficiency and response rather than alter the final drive ratio. Always confirm tooth count, bore fit and mounting details against your existing spur to prevent compatibility problems.

Can I use this with brushless motors?

Yes, it works with typical brushless or brushed motor pinions used in V One RRR setups; ensure pinion tooth count and fit are correct for your motor.

How do I prevent gear noise?

Set correct mesh, use thin shims if needed, and hand-spin the train to detect irregular contact; small mesh corrections usually eliminate whine.

Do I need to change my pinion?

Not unless you want a different final ratio. The 59-tooth spur keeps gearing consistent unless you fit a different pinion tooth count.

Copyright © 2008-2026 rcjaz.com.au All rights reserved