JR-OT08 is an aluminium front upper pivot made for Kyosho Optima 2016 front uprights, forming the top attachment point on the suspension upright. It is supplied as a single aluminium pivot intended to replace the original plastic unit for improved longevity.
The listing specifies fitment to Kyosho Optima 2016; verify your chassis upright measurements for any cross-model use. The component should be regarded as an aftermarket spare or hop-up option when servicing the front suspension.
Fitting steps: remove the wheel and disconnect steering links as required, separate the upright from the lower suspension arm and remove the existing pivot, fit the JR-OT08 aluminium pivot, then rebuild and check steering geometry and travel. No hardware list or torque recommendations are included here, so check the retailer listing for whether screws or bearings accompany the part.
Setup notes: installing an aluminium JR-OT08 pivot can help maintain alignment under impact and load, reducing pivot wear and contributing to steadier steering feel and consistent suspension action on track days or club runs.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
