The Kyosho LAW93GM front suspension holder D is a gunmetal-finished aluminum replacement made for LAZER SB models. It provides a stiffer mounting point where the original part is damaged or where improved front-end rigidity is needed for consistent handling.
Functionally it locates suspension arms and shock mounts, holds alignment under dynamic loads, and gives a repeatable reference for fine tuning. Use it as a direct replacement to recover original geometry after a crash or to reduce unwanted flex while dialing setup settings.
Follow standard service steps: remove the old holder, clean mating surfaces, and transfer any stock bushings or inserts that are compatible. Start screws by hand to check engagement and then tighten to the manufacturer's torque settings if those are known. After fitting, check suspension travel and steering geometry and run slow test laps before full-speed operation.
On the tuning side, a rigid aluminum holder can cut down front flex and help preserve camber and toe under braking and cornering. Coordinate the holder change with shock mount positions and arm shims to refine handling balance.
After impact inspections should focus on hairline cracks at mounting points, deformation of faces, and thread condition. Keep fasteners free of grit and apply thread-lock to metal-to-metal joints when needed. Replace the holder if any permanent damage is detected to ensure consistent geometry.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
