Item Brief
This RC-scale replacement is supplied as a Kyosho UBW006 spare part intended for the LAZER ZX line. The component is targeted at maintenance and repair tasks; its role is to restore mounting accuracy and predictable behaviour rather than to upgrade performance.
Described as a model-specific spare, it is intended to replicate original mounting points and interfaces used on LAZER ZX parts, so confirm compatibility before final assembly. During fitting, check linkages and fasteners for alignment, ensure moving parts run freely, and use thread-lock or washers where the original assembly specifies them.
In setup terms, swap this item to recover baseline handling prior to altering suspension, steering geometry, or drivetrain settings. Replace single worn elements and verify system operation before any tuning adjustments.
Mounting Advice
Handle the component as a precision RC assembly: keep small parts tidy and use the correct hex drivers. Reinstall fasteners to moderate torque values suitable for model hardware, assess play in pivots, and cycle linked parts to ensure there is no binding. If this part interfaces with servo, electronic speed controllers, or the motor wiring harness, match clearance and routing to the original layout to prevent chafing.
Maintenance Checks
After the first run, inspect replaced items for misalignment or premature wear. If handling changes, confirm that associated linkages and ball bearings are properly seated and free. For unresolved faults, compare mount points with Kyosho diagrams or check a parts list to confirm correct orientation.
