LAZER ZX7.5 Upgrade Swing Shaft 67 - Kyosho LA419-01  [KY-LA419-01]

Kyosho LA419-01 - Swing Shaft(67/1pc/ZX7.5)
Price:
AUD$15.31
Brand:
Kyosho
Model:
KY-LA419-01
GTIN:
4548565524228
Condition:
Brand New
Write a review

Service replacement shaft for LAZER ZX7.5

The Kyosho LA419-01 swing shaft is provided as a single replacement part intended for LAZER ZX7.5 chassis servicing and setup. The "67" size is identified in the part name and the item is meant to recover correct swing geometry on the stated model.

Use this shaft when the existing swing link shows play or damage, or when performing setup changes that require part swaps. The source lists fitment by model code and size rather than by material, so verify the "67" sizing against your current component before putting it into service.

Practical fitting notes: clear surrounding linkages for access, align components before final clamping, check for runout and lateral movement after install, and recheck bearings and adjacent fasteners to confirm secure mating. This product is supplied as an RC hobby accessory only.

Compatibility

Compatible with LAZER ZX7.5 according to the product designation.

A direct-fit swing shaft intended for repair and setup work on LAZER ZX7.5 chassis.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How will this shaft affect handling and tuning?

Installing a correct-size shaft restores design geometry, which can change toe and camber behavior slightly; follow your normal setup routine and re-evaluate handling after test runs.

Should I check related bearings when replacing the shaft?

Yes. Inspect bearings and interfacing hardware and replace or service any parts showing wear to prevent premature failure.

Any tips to reduce shaft runout during assembly?

Ensure mating surfaces are clean, align components before tightening, and gradually torque fasteners while checking for lateral movement to minimise runout.

Can I swap this shaft as part of a setup change between events?

Yes, it can be used during setup changes, but confirm the "67" size matches and carry out alignment and test runs after swapping.

Copyright © 2008-2026 rcjaz.com.au All rights reserved