M3 x 26 Cross Member Replacement HI2511003 for Helicopter Parts by Hirobo  [HI2511003]

HIROBO 2511-003 CROSS MEMBER M3 X 26 #2511003
Price:
AUD$7.81
Brand:
Hirobo
Model:
HI2511003
GTIN:
4512895113667
Condition:
Brand New
Write a review

Robust cross link M3 x 26

This Hirobo HI2511003 cross member is supplied as an RC replacement piece for general helicopter frames and assemblies. The M3 x 26 dimension specifies the thread diameter and length designed for standard M3 fasteners used across many helicopter designs.

Install this cross link when a rigid connection is needed to preserve alignment between mounts or to fasten small linkage setups. It provides a simple structural function that helps keep the aircraft's geometry stable for tuning.

Fitting notes: position the cross member into the existing mount holes, use the correct M3 fasteners with suitable thread engagement for your chassis, and tighten carefully to avoid stripping threads in delicate parts. This is a passive component, not a moving linkage.

What torque should I use on M3 fasteners?

Apply moderate torque suited to the chassis material; avoid over-tightening. When in doubt, use a low torque setting and confirm secure engagement without deformation.

Any alignment tips during fitting?

Hand-start the fasteners, check that the cross member sits flush, then progressively tighten while confirming free movement of connected linkages.

How often should I replace this part?

Replacement is typically only needed if the part is bent, threads are damaged, or mounting holes show wear from repeated service; inspect it during routine checks.

Copyright © 2008-2026 rcjaz.com.au All rights reserved