Maintenance Drive Bevel Shaft for LAZER ZX7.5 - LA404 Kyosho  [KY-LA404]

Kyosho LA404 - Drive Bevel Shaft Set (ZX7.5)
Price:
AUD$8.13
Brand:
Kyosho
Model:
KY-LA404
GTIN:
4548565524051
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $6.15 each $3.95 or 24%
3+ $5.54 each $7.77 or 32%
Write a review

Installation and Tuning Role of the LA404

The LA404 bevel shaft set from Kyosho fits LAZER ZX7.5 layouts as a serviceable replacement between the gearbox and final bevel gear. Its role is to restore precise bevel engagement so the driveline runs smoothly during tuning and setup.

This item is intended only for LAZER ZX7.5 compatibility; confirm your chassis code prior to purchase. It integrates with the original drivetrain layout and does not require altering the chassis for a standard installation.

Practical tips for fitting: secure the vehicle, remove the gearbox covers, examine adjacent gears and bearings for damage, clean contact surfaces, and apply thread-lock where the factory assembly used it. Proper alignment when installing will help preserve gear life and improve drivetrain feel.

For routine maintenance or tuning on LAZER ZX7.5 models, the Kyosho LA404 offers a practical replacement to keep the driveline performing predictably.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How does this part affect tuning adjustments?

Replacing a worn shaft with the LA404 stabilises bevel engagement, making gearmesh and throttle response more consistent during setup changes.

Any alignment tricks while installing?

Support the gearbox securely and check bevel faces for even contact before final tightening. Small shims or washer adjustments are rarely required if the original geometry was correct.

Is special lubrication needed?

Use a light gear grease on bevel faces and ensure bearings are adequately lubricated to reduce wear and noise across the driveline.

Should I use thread-lock on fasteners?

Apply thread-lock to fasteners that the factory originally secured to prevent loosening under vibration, following the recommended torque settings.

Copyright © 2008-2026 rcjaz.com.au All rights reserved