Medius X26 Antiroll Bar 1.3 Section Compatible with steel EP - Serpent 402195  [SER402195]

Serpent SER402195 Antiroll bar 1.3 X26
Price:
AUD$0.00
Brand:
Serpent
Model:
SER402195
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Fine-tune chassis roll on Medius X26

The Serpent 402195 anti-roll bar is an RC aftermarket component designed to modify chassis roll behaviour on compatible 1/10 electric touring car platforms. The 1.3mm section denotes a mid-range stiffness between thinner and heavier bars.

Compatibility is confined to the Medius X26 steel EP chassis family as documented in the Serpent Medius X26 steel EP (SER400052) parts grouping. Verify your chassis mounting layout before assuming fitment on any other model.

Installation attaches at the suspension linkages and end mounts used by the original bar. You will typically reuse the chassis' existing linkage hardware and mounting brackets; always check for unobstructed movement through the full suspension travel after fitting.

Tuning guidance: switching to a 1.3 section raises lateral roll stiffness and changes the front/rear roll rate balance. Apply one change at a time to clearly observe handling differences during setup.

When should I choose the 1.3 over a thinner bar?

Opt for the 1.3 section when you need a moderate increase in roll stiffness to reduce body roll without causing abrupt handling swings.

How do I assess the effect on understeer or oversteer?

Make a single change to either front or rear and test on the same track conditions; the 1.3 increases roll stiffness which will shift the balance depending on which axle it is fitted to.

Will changing the anti-roll bar affect suspension binding?

It can if the mounting geometry differs or if hardware is worn. After fitting, verify free movement through the full travel to avoid binding issues.

Copyright © 2008-2026 rcjaz.com.au All rights reserved