Medius X26 Compatible Bumper X26 - Serpent 402190  [SER402190]

Price:
AUD$160,924.96
Brand:
Serpent
Model:
SER402190
Condition:
Brand New
Write a review

Design and chassis interface

The Serpent 402190 Bumper X26 is a steel front bumper made as a replacement for Serpent Medius X26 steel EP assemblies listed under SER400052. It serves as the front structural mounting point, distributing contact forces and providing a repeatable datum for bumper height and alignment checks.

This component is suitable for hobby maintenance, repair, and tuning workflows where consistent fit and material repeatability are important. The description concentrates on fit and installation; confirm chassis compatibility and inspect the existing mounting hardware before fitting this piece.

Installation tips: verify the bumper orientation versus the old unit, line up the mounting holes to the chassis brackets, and make sure the bumper sits flush to the mounts to maintain designed clearance and shock travel. As mounting geometry can differ across kits, retain the original mounting pattern and use the supplied fasteners where applicable.

Specifications

  • Item: Bumper X26
  • Material: Steel
  • Model Number: SER402190
  • Compatibility: Medius X26 steel EP (SER400052)

The Serpent 402190 Bumper X26 is intended to restore correct front-end mounting geometry on Medius X26 steel EP kits and to support routine setup and repair tasks on 1/10 scale touring car chassis.

Does changing to this bumper affect steering feel?

Because the bumper defines front-end geometry, swapping materials or profiles can alter contact dynamics slightly; re-evaluate steering and front-end setup after installation.

How should bumper height be checked after replacement?

Use your usual setup gauge or reference points on the chassis to verify the bumper height and alignment, adjusting as necessary to match previous settings or desired clearance.

Will the steel bumper change weight distribution?

Any material swap can influence small weight changes at the front; while impact on overall balance is usually minor, consider this when chasing fine handling differences.

Is trimming or modification recommended?

Modifying a steel bumper is not generally recommended unless you have the correct tools and knowledge; altering the mounting points can affect alignment and should be avoided.

How frequently should I recheck bumper alignment?

Check alignment after any impact and as part of routine setup checks; early detection of misalignment prevents handling issues and uneven wear.

Copyright © 2008-2026 rcjaz.com.au All rights reserved