Medius X26 Rear Shockmount Tuning Set Serpent 402202  [SER402202]

Price:
AUD$0.00
Brand:
Serpent
Model:
SER402202
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

X26 Rear Shockmount Specifications

This Serpent 402202 component, described as "rr (2) X26", is supplied as a replacement rear shockmount set for the Medius X26 (SER400052) chassis. The set contains two mounts intended for tuning or restoring rear suspension mounting points without modifying scale parts.

The mounts are formed to align with the same attachment bosses used on the referenced Medius X26 parts, so installation normally follows the original shock tower and lower link geometry. During fitting, confirm fastener selection and check shaft clearance at full compression and droop.

For setup work, treat these as tuning items: mounting hole choice shifts lever length and roll center slightly and can be used to fine tune balance and response. They are handy when experimenting with shock positions or replacing worn parts after frequent setup changes.

How do different mounting holes change handling?

Selecting a higher or lower hole changes the effective lever arm and roll center, which alters weight transfer and midcorner balance. Test small increments to judge the handling effect.

Can I use these mounts to experiment with shock angles?

Yes. Swapping mount positions lets you try different shock angles and leverage setups; just document each change and recheck ride height and droop after every adjustment.

Any quick setup checks after swapping mounts?

After fitting, verify shock shaft travel, test for body or tyre interference, ensure fasteners are secure, and perform a short run to confirm the new setting behaves as expected.

Copyright © 2008-2026 rcjaz.com.au All rights reserved