Motor Mount Base A for Auper D6 SAK-D6808F/PU (Aluminum, Purple) by 3Racing  [SAK-D6808F/PU]

3RACING Auper D6 Aluminum Motor Mount Base A Purple - SAK-D6808F/PU
Price:
AUD$8.01
Brand:
3Racing
Model:
SAK-D6808F/PU
Condition:
Brand New
Write a review

Installation and Tuning Notes

This aluminum motor mount base A is a scale replacement designed to accept a variety of standard motor footprints used on the Auper D6 platform. It clamps the motor to the gearbox region and supplies a reliable datum for achieving correct pinion and spur alignment during setup and tuning.

Manufactured from machined aluminum to reduce flex and keep alignment stable after repeated runs. Fitment is intended for the Auper D6 as specified in the product name; verify chassis compatibility before fitting.

Fitting tips: the mount is compatible with the Auper D6 screw pattern, so install with correct thread engagement and then check the mesh while rotating the drivetrain. Fine axial or angular tweaks at the mount are a quick way to trim gear noise and enhance efficiency.

How should I set pinion spacing with this mount?

Start with the recommended mesh using a single sheet of paper between gears, tighten mounting screws, then rotate and listen for noise. Make micro-adjustments to axial position until you achieve smooth engagement.

Will changing mount position affect handling?

Minor axial moves affect drivetrain noise and efficiency more than chassis handling. Significant motor relocation can change weight balance; keep changes small and test lap times after adjustments.

Any quick tips to reduce gear whine?

Ensure correct mesh, use quality bearings, check for bent shafts, and consider a slight offset tweak at the mount to remove high frequency contact points.

Copyright © 2008-2026 rcjaz.com.au All rights reserved