MTX-4 Compatible 52T Delrin Spur Gear MTX4-0852/V2 by 3Racing  [MTX4-0852/V2]

Mugen Seiki MTX4 Low Friction Delrin Supr Gear 0.8 Pitch 52T Version 2 - 3RACING MTX4-0852/V2
Price:
AUD$3.29
Brand:
3Racing
Model:
MTX4-0852/V2
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

MTX-4 Compatible 52-Tooth Delrin Spur

This Version 2 spur is a 0.8 pitch, 52-tooth Delrin gear prepared for MTX-4 scale RC drivetrains. The Delrin material provides a low-friction, wear-resistant option aimed at lowering drag in the powertrain compared with some composite alternatives.

Install the gear as a direct swap into compatible MTX-4 gearboxes. When fitting, verify gear mesh against the motor pinion to prevent tight contact, trim any molding flash, and ensure the whole gearbox spins freely before conducting full-load runs. This item is an RC-scale component only.

Because it is Version 2, follow the usual MTX-4 spur replacement routine: align the gear correctly and secure the gearbox cover or retaining hardware as required by the chassis.

Can I swap this straight into an MTX-4?

Yes, it is designed to be a direct swap for the MTX-4 spur gear on compatible gearboxes.

Does Delrin wear differently than composite gears?

Delrin is generally low friction and wear-resistant, but check mesh and test under load to confirm long term compatibility with your drivetrain and pinion material.

What should I inspect after install?

Inspect for smooth rotation, absence of binding or noise, and verify screws remain tight after a short break-in run.

Copyright © 2008-2026 rcjaz.com.au All rights reserved