Mugen MTC3 Factory Pro O-MCP023R Graphite Upright Lever Off-Road Favourite  [FP-O-MCP023R]

Price:
AUD$12.59
Brand:
Factory Pro
Model:
FP-O-MCP023R
Condition:
Brand New
Write a review

Refine Front-End Control on the Mugen MTC3

The Factory Pro O-MCP023R graphite upright lever is made for the Mugen MTC3 and focuses on delivering a stiff, lightweight front end. This single-piece graphite part reduces flex in key steering areas to help maintain precise inputs when pushing the car hard.

Graphite Versus Other Materials

Graphite stands out for delivering rigidity without excess mass, helping drivers achieve more predictable steering behaviour. In the Mugen MTC3, that translates to improved turn-in and steadier mid-corner balance.

Quick Install and Setup Tips

Installing the Factory Pro O-MCP023R is a direct fit to the Mugen MTC3 chassis. After fitting, check steering geometry and confirm there is no binding, then fine-tune toe and camber for your preferred handling balance.

Will this change steering sensitivity?

You will notice crisper steering input with reduced compliance. Adjusting dual rates or endpoint settings on your radio can help tune the sensitivity to suit driving style.

Do I need to change my servo?

A high-torque digital servo is recommended for precise control, but the upright itself does not mandate a servo swap unless current gear torque is marginal.

How should I maintain graphite parts?

Keep mating surfaces clean, avoid over-tightening screws, and inspect for hairline damage after heavy impacts to ensure long service life.

Is additional setup needed for different track surfaces?

Yes. Softer surfaces may benefit from more steering toe-in or increased rear traction, while high-grip tracks may need reduced toe to prevent twitchy behaviour.

Copyright © 2008-2026 rcjaz.com.au All rights reserved