Nylon Brake Levers for SRX8 Gen4 Serpent 601371  [SER601371]

SRX8 Gen4 compatible nylon brake lever set

The Serpent 601371 group of nylon brake levers is produced as an RC replacement intended specifically for SRX8 Gen4 brake systems. Nylon construction helps maintain consistent flex and wear behavior under normal operating conditions versus degraded plastic parts.

This kit is matched to the SRX8 Gen4 bell crank geometry listed in the name, so confirm your chassis mounting matches before proceeding. Installation is straightforward: remove the worn lever, transfer pins and hardware, place the new nylon lever in the same orientation, and check for smooth movement through the full brake travel.

In setup, expect a modest change in pedal modulation when switching materials; these levers are typically used to restore reliable actuation during servicing. After fitting, ensure free rotation without binding and re-verify link clearances following a short test drive.