Outlaw Rampage PRO 2.0 Compatible Rear Stabilizer OLW009 - Kyosho  [KY-OLW009]

Kyosho OLW009 - Rear Stabilizer(1.8/2.2/2.6mm/2RSA)
Price:
AUD$0.00
Brand:
Kyosho
Model:
KY-OLW009
GTIN:
4548565522316
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Component Overview

The Kyosho OLW009 is supplied in 1.8, 2.2, 2.6mm and 2RSA variants and is designed as a drop-in rear stabilizer for the Kyosho Outlaw Rampage PRO 2.0 truck series. It operates as a rear sway bar to influence roll resistance and the rear-end response during cornering and traction shifts.

Installation is straightforward for anyone accustomed to rear linkage service: remove the existing stabilizer, fit the chosen OLW009 item and secure it with the original fasteners. Common hex drivers and standard fasteners are used, and no chassis alterations are typically necessary on the specified platform.

Tuning notes: swapping between the 1.8, 2.2 and 2.6 sizes alters rear roll stiffness predictably; thicker options increase roll control while thinner ones promote more independent wheel movement. The 2RSA variant provides an alternate feel, so apply incremental changes and test on the same surface to judge differences.

Post-run checks are recommended to ensure all hardware is secure and to inspect linkages for wear; replacement timing depends on how and where you run the truck.

This stabilizer is a targeted upgrade for fine-tuning rear handling on the Outlaw Rampage PRO 2.0, helping drivers dial rear roll stiffness to match surface and layout demands.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How does the OLW009 alter corner entry and mid-corner behaviour?

Changing to a stiffer OLW009 increases rear roll control, which can tighten corner entry and reduce mid-corner body roll. Softer options free up rear wheel movement and can help rotation.

Is there a recommended progression between the sizes?

A sensible approach is to change one size at a time and evaluate performance. Move from 1.8 to 2.2, then to 2.6 if more roll control is required, noting lap times and handling feel.

Can I tune rear roll without swapping other components?

Yes, the OLW009 lets you adjust rear roll independently, but bear in mind that shocks, springs and toe can interact with the stabilizer setting, so tune holistically if needed.

What basic tools do I need for a safe swap?

A set of hex drivers, small pliers and a clean workspace are sufficient. Work methodically and keep track of hardware to ensure correct reassembly.

How can I tell the stabilizer needs replacing?

Signs include visible bending, loosened mount points that do not stay tight, or a change in handling that cannot be corrected by re-tightening fasteners. Replace the part if performance is affected.

Is the OLW009 compatible with aftermarket link kits?

Compatibility with aftermarket link kits depends on link geometry. The OLW009 is designed for the stock geometry of the Outlaw Rampage PRO 2.0, so verify fitment when using non-standard link sets.

Copyright © 2008-2026 rcjaz.com.au All rights reserved