Outrunner Shaft 5mm for S-3008 Series - Scorpion SPS3008MSK  [SPS3008MSK]

SCORPION S-3008 SERIES OUTRUNNER MOTOR SHAFT KIT 5MM SHAFT
Price:
AUD$6.37
Brand:
Scorpion
Model:
SPS3008MSK
Condition:
Brand New
Write a review

Replacement shaft for S-3008 outrunners

The Scorpion SPS3008MSK is a replacement shaft designed for use with Scorpion S-3008 series outrunner motors. It restores the correct 5mm shaft interface when the original component is damaged or worn.

Recommended procedure: remove the motor endbell, inspect and replace any compromised bearings, install the SPS3008MSK shaft, and ensure bearings are seated squarely. Proper installation reduces vibration and protects bearing life in brushless RC motors.

After fitting, confirm smooth rotation under no load and recheck gear or pulley alignment before returning the motor to service. The part is sold as a single shaft for hobby motor maintenance and does not necessarily include extra fixings.

Will fitting a new shaft affect my motor tuning?

Installing the SPS3008MSK restores mechanical alignment; generally it stabilizes motor behavior under load, but verify timing and gear alignment after reassembly to confirm tuning remains consistent.

What should I watch for when seating bearings?

Ensure bearings are pressed straight with no tilt, check for free spin with no binding, and confirm there is no lateral play once the SPS3008MSK shaft is installed.

Can I reuse the motor's original pinion or pulley?

If the pinion or pulley mounting surfaces are undamaged and alignment is preserved after fitting the new shaft, reuse is acceptable; always verify mesh and set-screw security.

Copyright © 2008-2026 rcjaz.com.au All rights reserved