This R/C-scale side plate is a Yokomo-produced replacement intended for the GOKURAKU Wing Ver 4.0 assembly. It is manufactured to restore or slightly alter the wing mounting interface without the need to change the chassis.
The plate supplies the mounting interface for the wing endplate and transfers incremental setup adjustments to wing incidence and lateral position. Installing this part makes it easier to perform controlled wing setup changes while testing to influence stability and corner entry behavior on 1/10 touring cars.
Installation is simple and uses the wing's current mounting points and hardware; remove the original plate, line up the replacement with the same holes, and fasten with the existing screws. Verify thread condition and screw length before final tightening, and make sure the wing sits symmetrically on both sides.
Tuning notes: small side plate adjustments will change the effective wing angle and side-to-side placement, so alter one parameter at a time and judge the results by handling feel or lap times. Treat this as a neutral replacement or a tool for incremental wing tuning rather than a single-step performance upgrade.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
