RADTEC RAD-MA-10006 150mm Flat Bonded Flex Sensor Harness - Heavy Duty  [RAD-MA-10006]

RAD-MA-10006 150mm FLAT BONDED Flex Sensor Wires
Price:
AUD$4.83
Brand:
RADTEC
Model:
RAD-MA-10006
Condition:
Brand New
Write a review

Rugged Flat-Bonded Sensor Harness

When you need a robust sensor lead for aggressive running, the RADTEC RAD-MA-10006 150mm flat bonded flex sensor wires provide a secure pathway for the motor-ESC sensor signal. The bond and flex design focuses on durability and reliable contact under vibration.

Built for Tough Conditions

The flat bonded finish resists chafing and keeps the cable profile low, reducing the chance of snagging on suspension parts. At 150mm the wire offers practical reach while remaining compact enough to mount cleanly in tighter chassis.

Typical Applications

These sensor harnesses are suited to heavier duty off-road rigs and bashers where resilient connections are essential for consistent motor timing and throttle control.

Can these wires handle vibration from big bore shocks?

Yes, the flat bonded assembly helps reduce movement and wear under vibration, though good strain relief at connection points is still recommended.

Do I need a special connector to use them?

They use standard sensor pin spacing compatible with common motor and ESC headers. No special adapter is typically required unless your equipment uses a nonstandard layout.

Are they suitable for long term outdoor use?

The bonded flat design adds abrasion resistance, making them a good choice for outdoor running, but keep connectors protected from moisture and heavy dirt for best longevity.

Any recommended maintenance?

Check for frays and secure connectors after heavy sessions. Reapply minimal dielectric grease on exposed pins if you run in dusty or wet conditions.

Copyright © 2008-2025 rcjaz.com.au All rights reserved