RADTEC RAD-XR-20034 Aluminium Camber Inserts for XRAY X1 2 Pack  [RAD-XR-20034]

RAD-XR-20034 Aluminum Camber Bushing for X1, 2 Dots, 1.0/3.0 deg, 2 pcs
Price:
AUD$10.70
Brand:
RADTEC
Model:
RAD-XR-20034
Condition:
Brand New
Write a review

Precision Camber Inserts for XRAY X1

Racers running the XRAY X1 can use the RADTEC RAD-XR-20034 camber inserts to make measured camber changes without swapping complex parts. This two-piece aluminium set is matched for older X Series chassis and provides 1.0 and 3.0 degree settings.

Use Scenarios and Benefits

These aluminium bushings are built to improve repeatability in front-end geometry, helping drivers fine-tune understeer and turn-in grip. They are best applied when small adjustments change the car balance noticeably.

Simple Fitment Guide

Installation is quick using basic tools; clean contact areas before fitting to avoid binding. The robust aluminium construction resists deformation, keeping camber settings stable over many runs.

Will these work with modern X1 upgrades?

Compatibility depends on the revision of the X1 upgrade parts; measure the mounting interface and compare before fitting to ensure correct seating.

How do aluminium bushings change handling feel?

Aluminium reduces flex compared with plastic, so steering response feels firmer and camber settings stay more predictable during hard cornering.

Can I reuse these after crashes?

Minor impacts are fine, but inspect for bends or burrs. Replace if the bushings no longer locate cleanly or if they develop visible damage.

Copyright © 2008-2026 rcjaz.com.au All rights reserved