RADTEC RAD-YK-10018 BD8-2017 Aluminium C-Hub 0 Degree Upgrade  [RAD-YK-10018]

RAD-YK-10018 BD8-2017 Aluminum C-Hub for RTC, 0 Deg
Price:
AUD$42.81
Brand:
RADTEC
Model:
RAD-YK-10018
Condition:
Brand New
Write a review

Tighten Up Steering Response

For Yokomo BD8-2017 rigs wanting sharper turn-in, the RADTEC RAD-YK-10018 aluminium C-Hub is a solid upgrade. The 0 degree setup holds neutral camber for predictable handling at speed.

Alloy Construction for Tough Tracks

Made from aluminium, this C-Hub reduces flex compared with standard plastic parts and stands up better to repeated use on abrasive surfaces. That improves repeatability when running mixed-condition tracks.

Simple Swap-In Installation

The part is tailored to the BD8-2017 bolt pattern so you can replace the factory hubs without cutting or modifying the chassis. It installs cleanly with stock screws and mounts.

Will this hub alter steering ackermann or track width?

The RAD-YK-10018 keeps the original mounting geometry, so ackermann and track width stay the same unless you change uprights or tie rods.

Is aluminium prone to cracking versus plastic?

Aluminium resists wear but can bend on very hard impacts; however it is less likely to gouge or deform under normal racing stress compared with softer plastics.

Do I need to re-tune my suspension after fitting this hub?

You may want to fine-tune front damping or roll centre settings to match the slightly firmer front response, but major changes are rarely necessary.

Copyright © 2008-2026 rcjaz.com.au All rights reserved