RC Helicopter Flat Washer 6x10x0.3T Hirobo HI2506064 — Thin Shim  [HI2506064]

Thin shim for accurate spacing

Sold under HIROBO 2506-064 (HI2506064), this flat washer is a low-profile spacer that functions as a simple load distributor in model assemblies. The marking shows dimensions of 6×10 with a 0.3T thickness, appropriate when you need very thin, even spacing.

In tuning and setup use the washer to spread screw clamping loads, stabilise small bearings or bushings, and set axial clearances without adding bulk. The listing does not give a material type, so choose fasteners and treatment that suit the parts in your model.

Practical fitting advice: place the washer where it separates mating surfaces or under a fastening head, confirm the inner bore fits the intended bolt or shaft, and test operation after fitting. For repeatable adjustments, use matching washers across similar mounting points.