Replacement I-Type Lever A for Eagle Series Linkages HI0404627 - Hirobo  [HI0404627]

HIROBO 0404-627 EAGLE I-TYPE LEVER A #0404627
Price:
AUD$20.82
Brand:
Hirobo
Model:
HI0404627
GTIN:
4512895108687
Condition:
Brand New
Write a review

Durable I-Type Lever for Linkage Repairs

The Hirobo HI0404627 I-Type Lever A is an aftermarket-style replacement part for the Eagle family and compatible models. It is intended to replace degraded I-Type levers and restore a solid connection in the rotor control linkage.

Installation follows standard linkage repair practice: remove the old lever, fit the HI0404627 to the ball joint or arm in the same orientation, and secure the original hardware. After fitting, cycle the controls at low throttle to confirm smooth travel and correct alignment.

Replacing a worn lever can noticeably reduce play and return more linear control response. Inspect ball-seat engagement and measure end-to-end travel on the related control rod, then adjust servo endpoints as needed to maintain symmetric throws.

What is the expected wear resistance of this lever?

Wear will depend on use and conditions, but replacing bent or worn levers with the HI0404627 will restore solid contact and delay further play when inspected and fitted correctly.

Can fitting this part reduce control play?

Yes. A new lever that seats correctly at the ball link typically reduces measurable play and improves linearity of the control response.

How often should I inspect this linkage after replacement?

Check linkage seating and play during routine pre-flight inspections and after any hard landing; more frequent checks are advised for high-use or aggressive flying styles.

Copyright © 2008-2026 rcjaz.com.au All rights reserved