Revo Throttle Mixing Arm for Traxxas - Silver 2 Ball Bearings RE-051/S by 3Racing  [RE-051/S]

Throttle arm overview for Revo

This is an aftermarket throttle mixing arm intended for Traxxas Revo linkage, listed under model RE-051/S. The silver plated appearance and two included ball bearings help lower friction where the linkage pivots, aiming for a more predictable throttle action.

The component is intended to replace the factory mixing arm on Revo models, providing a precise pivot between the servo linkage and the carburettor or throttle assembly. Bearings at the rotation points reduce the chances of binding and inconsistent throttle response seen with worn plastic arms.

Fitment and setup advice: install to the Revo linkage points, make sure bearings are fully seated, and run the servo through full travel to check for smooth movement. Small clevis or length adjustments may be necessary to remove any end-of-throw tightness and to restore correct idle position. Perform a bench check of throttle return before driving on-track or off-road.