ROCHE 220215 - Rapide F1-EVO2 Performance Graphite Rear Wing Plate  [RH-220215]

ROCHE 220215 Rapide F1-EVO2 Graphite Rear Wing Mount Plate C20223
Price:
AUD$22.70
Brand:
ROCHE
Model:
RH-220215
Condition:
Brand New
Write a review

Graphite Upgrade for Better Rear Stability

The ROCHE 220215 - Rapide F1-EVO2 Graphite Rear Wing Mount Plate is built for the Rapide F1 EVO2 chassis to give a stiffer mounting point for the rear wing. Constructed from durable graphite, the plate helps smooth airflow over the wing and reduces flex, which can lead to steadier handling during aggressive driving. Its lightweight nature keeps overall mass down while adding structural support where it matters.

Benefits of Graphite in RC Wings

Graphite offers a high strength to weight ratio, giving stronger support without significant weight gain. The ROCHE 220215 improves the rear wing's resistance to bending, promoting consistent downforce and more predictable cornering behaviour.

Secure Mounting and Alignment Tips

When fitting the ROCHE 220215 Graphite Rear Wing Mount Plate, use correctly sized screws and ensure even torque across mounting points. Check the wing alignment after installation and make small angle changes to find the best balance for your setup.

Do I need adhesive to mount the plate?

Adhesive is not normally required; secure the plate with properly sized screws and consider a mild threadlocker for endurance runs if desired.

Will the mount change servo or linkage load?

Because the plate stiffens the wing, servo loads can shift slightly. Check linkages and ensure the servo can handle any additional resistance at full deflection.

Is the plate suitable for rough track surfaces?

The graphite plate increases rigidity which helps maintain wing position over rough sections, but inspect the mount after heavy impacts for any signs of damage.

Copyright © 2008-2025 rcjaz.com.au All rights reserved