ROCHE 340073 Steering Knuckle Set Heavy Use Edition  [RH-340073]

ROCHE 340073 Steering Knuckle Set
Price:
AUD$8.32
Brand:
ROCHE
Model:
RH-340073
Condition:
Brand New
Write a review

Sturdy ROCHE 340073 Knuckle Set for Active RC Use

The ROCHE 340073 Steering Knuckle Set is built for hobbyists who put their models through regular sessions and need parts that hold alignment. It is suitable for both trimming and routine repair tasks.

Where It Fits

Compatible with many 1/10 scale platforms, these knuckles are a practical swap-in for cars and off-road models that share similar steering layouts. They aim to keep toe and camber behavior consistent after installation.

Practical Mounting Advice

Ensure pivot points are free of grit and use thread locker on applicable fasteners for race use. Recheck tie rod lengths after fitting to maintain correct steering geometry.

Do I need special parts to fit ROCHE 340073?

Most installs use existing hardware, but check that ball studs and hubs match the knuckle's mounting pattern; some setups require minor hardware changes.

Is a full alignment needed after replacement?

After replacing knuckles, perform a basic alignment check and adjust tie rods as needed to restore correct toe and steering centering.

How do I inspect for damage?

Look for hairline cracks, worn bearing seats, or excessive lateral movement. Replace any knuckle that shows structural damage to avoid steering failure.

Can I upgrade to metal ball studs?

Yes, swapping to hardened ball studs can improve durability, just confirm thread sizes and lengths match your knuckles and steering links.

Copyright © 2008-2025 rcjaz.com.au All rights reserved