SAK-D6807C/PU Purple Front Mono Shock for Auper D6 by 3Racing  [SAK-D6807C/PU]

Price:
AUD$19.70
Brand:
3Racing
Model:
SAK-D6807C/PU
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Front mono absorber with purple finish

This front mono shock is intended for the Auper D6 chassis, providing a single-shock mounting choice for the front suspension. The component is coloured purple and is offered as a direct replacement or hop-up for Auper D6 mono front layouts.

Installation is performed using the chassis front shock mounts and common mounting hardware; the part swaps in for the stock front mono absorber and works with the existing front suspension link setup on the Auper D6 without requiring chassis alteration when fitted to the correct points.

When setting up the car, expect the mono absorber to modify front load distribution. Adjustments to springs and shock oil are the normal way to tune balance, turn-in characteristics, and traction for circuit or practice runs.

Will I need extra brackets or spacers to mount this?

In most cases no extra brackets are necessary; the absorber is intended to use the standard Auper D6 front mounting points. Verify your mount orientation and hardware before final assembly.

Are springs or other hardware included with the unit?

This description does not state included springs. It is recommended to fit springs and shock oil matched to your setup when replacing the factory mono absorber.

Any tips for aligning the mono absorber during install?

Ensure the absorber eyelets sit square in the mount points and that linkage geometry is unchanged. Tighten mounting hardware progressively and check for binding through full suspension travel.

Copyright © 2008-2026 rcjaz.com.au All rights reserved