SAVAGE XS FLUX 7075-T6 Rear Lower Arm DT4056 Aftermarket by GPM  [DT4056]

Replacement rear lower suspension arm for SAVAGE XS FLUX

This rear lower suspension arm is manufactured from 7075-T6 aluminium alloy as an aftermarket upgrade for the rear lower suspension area on compatible models. The part is available anodized in sky blue, black, or silver and is supplied with the necessary pins and screws to make installation straightforward. Where applicable, hardware items are pre-assembled, and the supplier recommends medium-strength screw glue to help keep fasteners secure during running.

The alloy design aims to combine robust strength with reduced weight when compared to common plastic components, helping the suspension retain correct geometry under heavier loads or uneven ground without implying any real vehicle use. Fit this arm to replace damaged original parts, maintain accurate pivot locations, or fine-tune suspension behaviour. Re-check symmetry and clearance after fitting as handling may be affected.

Installation notes: remove the stock rear lower suspension arm and move any bearings or inserts as required, position the replacement arm on the mounting points, secure with the included stainless steel pins and Grade 12.9 black round head screws, and apply medium-strength screw glue where recommended. Confirm free suspension movement before the first run.

This aluminium arm acts as a direct aftermarket replacement for the rear lower suspension on the listed vehicles, suited to repairs and stepwise tuning upgrades.