Schumacher Mi10 Rear Bulkhead +1mm Graphite 3.0 Upgrade Plate O-SCP046-1 by Factory Pro  [FP-O-SCP046-1]

Price:
AUD$15.73
Brand:
Factory Pro
Model:
FP-O-SCP046-1
Condition:
Brand New
Write a review

Graphite +1mm rear bulkhead for Mi10 chassis

Made by Factory Pro as an aftermarket alternative, this rear bulkhead plate suits the Schumacher Mi10 RC chassis. The item is formed from Graphite 3.0 and specified as a +1mm offset plate supplied as 1 pair (2 pcs).

Fitting this plate replaces the stock rear bulkhead and increases rear hub spacing by +1mm, giving you the option to tweak rear track and geometry without moving suspension mounts. Use it to dial in rear traction or to compensate for different tyre choices on the Mi10 platform.

Fitment tips: mount the plate where the original rear bulkhead sits, check bearing seat alignment and mounting hole position, and confirm there is no interference with drives or suspension travel after installation. This component is intended for tuning and setup only.

Will installation affect my driveshafts?

The +1mm offset alters hub spacing; verify driveshaft clearance and joint alignment after fitting to avoid binding.

Is tapping or trimming required?

In standard Mi10 setups the plate installs without trimming, but always check fitment on your specific chassis before final assembly.

Will this change handling a lot?

A +1mm change is a small, precise adjustment intended for fine tuning rather than wholesale handling shifts; it helps refine balance and rear grip tuning.

Copyright © 2008-2026 rcjaz.com.au All rights reserved