Schumacher Mi10/Mi9/Mi8 HGT Front Split Top Plate - Graphite 2.0 O-SCP043 by Factory Pro  [FP-O-SCP043]

Price:
AUD$17.49
Brand:
Factory Pro
Model:
FP-O-SCP043
Condition:
Brand New
Write a review

Front split top plate for Schumacher Mi10 chassis

This split upper deck is an aftermarket front top plate engineered as a direct-fit solution for Schumacher Mi10, Mi9 and Mi8 HGT platforms. Machined Graphite 2.0 gives a stiffer mounting plane versus stock plastic pieces and the split design helps localise flex between the front bulkhead area and the servo mount.

Installation uses the chassis' existing mounting points for Schumacher Mi10-series frames and is intended to replace the factory upper deck without major modification. Always verify fitment against your chassis and check clearances during assembly. The upgrade changes front structural stiffness and is not intended to change suspension pickup geometry.

Setup impact: the graphite split deck raises front-end stiffness, influencing steering precision and initial bite. Racers often swap this deck to tune transient response and front balance on carpet and paved surfaces. After fitting, review front-end adjustments to keep handling predictable.

Compatibility: Schumacher Mi10, Mi9, Mi8 HGT platforms.

Does this plate change suspension geometry?

No. The split upper deck is intended to alter front chassis stiffness rather than suspension geometry; control arm and pickup positions remain unchanged by this part.

Will this improve steering on low-grip surfaces?

Increasing front stiffness with Graphite 2.0 typically sharpens steering response and increases entry bite, which can help on low-grip layouts, but gains depend on the whole chassis setup.

What should I check after installing the deck?

After installation, verify screw torque, check for any new binding in the servo area, and re-evaluate front-end settings such as camber and toe to account for the altered stiffness.

Copyright © 2008-2026 rcjaz.com.au All rights reserved