Scorpion SPS3014MSK S-3014 5mm Motor Shaft Replacement Kit  [SPS3014MSK]

S-3014 Motor Shaft Details

The kit provides a direct-replacement 5mm shaft for Scorpion S-3014 series outrunner motors. The shaft is sized to match S-3014 motor geometry so it seats into the factory bearing bores and lines up with the existing pinion and spur arrangements used in the series.

Replace the shaft if your motor exhibits axial play, excessive runout, or if the original shaft shows wear. A correct replacement improves shaft alignment, reduces uneven bearing wear, and helps the motor run more smoothly, which is important when fine-tuning gear mesh and motor mounting.

Installation notes: designed for direct fit within S-3014 outrunner assemblies and compatible with the motor's stock internal layout. Make sure the shaft is fully seated in the bearing journal and that pinion engagement is set correctly before final assembly. After installation, confirm free rotation and check for minimal wobble at low-speed rotation prior to refitting the motor into the model.