Serpent 500889 Rear Right 13mm Shock Body Replacement for RC Dampers  [SER500889]

Serpent SER500889 Shock 13mm body rr
Price:
AUD$0.00
Brand:
Serpent
Model:
SER500889
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Service Sleeve for Rear-Right Shock (13mm)

This 13mm shock body is a service replacement for the rear-right damper, designed to hold shock internals in correct alignment during rebuilds. It is intended for use on remote-controlled cars when a sleeve needs replacement.

Use the component when repairing or fine-tuning dampers; while the body itself does not determine damping curves, replacing a worn sleeve can change the feel by restoring proper geometry, with tuning completed via piston, oil and spring choices.

Procedure: remove the shock, fully drain fluid, remove the cap and internals, swap bodies, then reassemble checking for free shaft motion and proper seal contact. Measure stroke and clearance before final installation to the suspension arm.

How does this sleeve influence tuning?

By ensuring the housing is correct, the sleeve helps maintain consistent piston travel; to alter damping you must change piston profile, oil viscosity or spring rate.

Is this suitable for tuning between runs?

Yes. Replacing damaged sleeves between runs helps keep damping behaviour consistent and predictable during successive sessions.

Which checks matter for a clean install?

Inspect shaft straightness, check for burrs on the body, ensure seals seat correctly and confirm unobstructed shaft motion before refilling.

Copyright © 2008-2026 rcjaz.com.au All rights reserved