Serpent 804280 Front Bearing Bracket Off-Road Strength [SER804280]

Serpent SER804280 Bearing Bracket Front UP

Price:

AUD$16.19

Brand:

Serpent

Model:

SER804280

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Serpent - Natrix Series - Natrix 748 TQ 200mm GP car (SER804008)

Reinforced Bracket for Aggressive Off-Road Use

The Serpent 804280 front bearing bracket is designed to withstand heavier loads and keep the front assembly aligned when you push your RC off-road. Its construction helps reduce flex and maintain predictable steering response over rough terrain.

Do I need special bearings for this bracket?

The bracket is intended to accept the same bearing sizes used in the original assembly. Confirm bearing dimensions against your existing parts to ensure a correct fit.

Will it work with aluminium uprights and hubs?

Compatibility depends on matching mounting points. If the bolt pattern lines up, it should integrate fine; always trial-fit components before final assembly.

How do I verify alignment after installation?

Check wheel runout and use a straightedge or alignment jig where available, then do a short test drive and fine tune toe and camber to dial in handling.