Serpent Medius X26 Graphite Front Lower Arm Upgrade O-SPP007F by Factory Pro  [FP-O-SPP007F]

Price:
AUD$15.73
Brand:
Factory Pro
Model:
FP-O-SPP007F
Condition:
Brand New
Write a review

Front Suspension Arm Specs

Factory Pro supplies this graphite front lower suspension arm for the Serpent Medius X26 as model O-SPP007F. The component is a single-piece graphite unit intended to replace the stock lower arm and focus on handling improvements rather than appearance.

The graphite construction increases axle support stiffness relative to typical composite arms, which can produce quicker steering response when camber and roll settings are adjusted. This makes it suitable for incremental tuning during setup sessions.

Installation requires swapping out the existing front lower arm on the Medius X26 chassis; always check alignment and handling after fitting. The kit includes one pcs.

How does the graphite arm hold up compared to stock parts?

Graphite increases stiffness and handling precision but reacts differently under impact than composite pieces; it is chosen primarily for improved response rather than impact tolerance.

Will I need to change spring or damper settings after fitting?

Possibly. Increased front stiffness can influence balance, so small spring or damper adjustments and test laps are recommended to re-tune handling.

Is this a direct replacement for the Medius X26 lower arm?

Yes, the O-SPP007F is intended as a direct front lower arm replacement for the Serpent Medius X26.

Copyright © 2008-2026 rcjaz.com.au All rights reserved