Serpent 401011 Mid-Shaft Bracket R Aluminium 1/10 Racing Part  [SER401011]

Serpent SER401011 Mid-shaft Bracket R Aluminium
Price:
AUD$26.53
Brand:
Serpent
Model:
SER401011
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Boost chassis rigidity with Serpent 401011

The Serpent 401011 Mid-Shaft Bracket R is an aluminium component made for the S400 and S411 series. Designed for 1/10 scale setups, it stiffens the central chassis area to help the car hold its line better under load.

Material advantages for competition

Aluminium parts are prized for combining low mass with robust performance. This bracket takes advantage of those traits to offer a reliable, race-capable solution without adding excess weight.

Fitment and replacement guidance

This mid-shaft bracket is intended for Serpent S400 1/10 190mm EP models and installs using the standard mounting hardware. Use it as a performance upgrade or to replace a damaged factory bracket.

Can I use this bracket on both S400 and S411 cars?

Yes. It is manufactured to fit both S400 and S411 series so you can swap it between compatible chassis without modification.

Will swapping to aluminium affect ride height?

The bracket itself is unlikely to change ride height significantly. Any handling change is mainly from increased torsional stiffness rather than a change in ride geometry.

Is any post-install setup recommended?

After fitting, check alignment and fastener tightness and run a few test laps. Small suspension or toe adjustments can help tune the car to the new stiffness.

Copyright © 2008-2025 rcjaz.com.au All rights reserved