Serpent 401647 Carbon Front Stiffener for Project 4X [SER401647]

Serpent SER401647 Stiffenerplate Front Carbon 4-X

Price:

AUD$16.68

Brand:

Serpent

Model:

SER401647

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Refine Project 4X Steering with the Serpent 401647

The Serpent 401647 Carbon Front Stiffener Plate is a focused chassis upgrade for the Project 4X Touringcar. Fitting this carbon plate reinforces the front section of the EP 190mm chassis, helping to stabilise steering and reduce flex under hard driving while keeping overall weight low.

Performance Advantages

Material: Lightweight, durable carbon fiber to improve chassis response.
Compatibility: Made specifically for the Project 4X Touringcar EP 190mm chassis for direct fitment.
Functionality: Stiffens the front end to enhance control and predictability at speed.

Practical Installation Tips

Fitting the Serpent 401647 is a quick upgrade in the pit or workshop. After mounting, verify caster and toe settings to get the most from the increased stiffness and achieve a predictable turn-in feel.

Will the plate improve lap times?

It can improve consistency in fast corners by reducing chassis flex, which often translates to better lap-to-lap repeatability rather than a fixed time gain.

Can I run this with my current electronics?

Yes, the stiffener does not interfere with electronics placement. Check that servo and battery clearances remain acceptable after fitting.

Does it make the car harsher over bumps?

Increasing chassis stiffness can make feedback through the suspension more pronounced; tune dampers and anti-roll settings to maintain compliance where needed.