Serpent 401736 Hard Wishbones 1/10 Race Spec  [SER401736]

Serpent SER401736 Wishbone Upper Front/Rear Hard 4X (2)
Price:
AUD$13.90
Brand:
Serpent
Model:
SER401736
Condition:
Brand New
Write a review

Strengthen Your Suspension with Serpent Arms

The Serpent 401736 Hard Wishbone Set fits front and rear suspension on 1/10 scale RC cars and provides a firmer arm option to help control movement during hard driving.

Durable Design for Aggressive Driving

These Serpent wishbones are manufactured to resist impact and fatigue so alignment stays consistent when pushing hard on loose or rugged surfaces. That durability translates to steadier laps and less tuning drift.

Pack Contents and Installation Notes

The kit contains four wishbones to replace both front and rear arms on compatible 1/10 models. They install with standard fasteners and allow quick swaps when you need a tougher setup.

Do Serpent 401736 wishbones need special hardware?

Most installations use the same pins and screws as stock arms. Inspect your car's mounting hardware and reuse or replace small parts as required.

Will heavier wishbones change handling balance?

A slightly stiffer arm can shift feel at the front or rear, so test under controlled conditions and fine tune springs or toe settings after fitting.

Can I use these on off-road buggies?

They are suitable for many 1/10 platforms, including some buggies, provided the mounting geometry matches. Confirm dimensions before fitting to off-road models.

Copyright © 2008-2025 rcjaz.com.au All rights reserved