Serpent SER401791 Project 4X PRO Rear 3-Point Wheelhub Set Left Right  [SER401791]

Serpent SER401791 Wheelhub Rear 3 point Left + Right 4X PRO
Price:
AUD$15.62
Brand:
Serpent
Model:
SER401791
Condition:
Brand New
Write a review

Rear Hub Upgrade Built for Handling

The Serpent SER401791 wheelhub is intended for the Project 4X PRO range. Provided as a left and right set, it gives a reliable handling upgrade for sprint and track use.

Stable Load Distribution

With a three-point anchor layout, the hub spreads forces evenly to reduce sudden rear-end shifts. That balanced setup improves driver confidence during mid-corner and exit phases.

Easy Fitment and Compatibility

This wheelhub fits the Project 4X PRO EP (SER400032) platform and is installed with standard RC tools, allowing straightforward swaps or refreshes at the bench.

Is special preparation needed before installing the hub?

Clean mating surfaces and check fasteners and bearings for wear. Light grease on bearings and correct torque on mounting hardware will help longevity.

Can I use this hub with aftermarket drive parts?

It is designed for Project 4X PRO geometry; many aftermarket parts are compatible but confirm dimensions before mixing components to ensure fit and alignment.

Will the hub affect handling balance noticeably?

Yes, swapping to the three-point Serpent SER401791 hubs can change rear response. For a balanced setup, consider changing both sides and rechecking alignment after installation.

Copyright © 2008-2025 rcjaz.com.au All rights reserved