Serpent SER401794 Topdeck Bushing - Chassis Stabiliser  [SER401794]

Serpent SER401794 Topdeck bushing 4X PRO
Price:
AUD$33.08
Brand:
Serpent
Model:
SER401794
Condition:
Brand New
Write a review

Chassis Consistency Using Serpent SER401794

Hobbyists tuning Serpent Project 4X PRO EP cars can use the SER401794 topdeck bushing to bring greater consistency to their setup. The component helps the topdeck seat correctly, limiting movement under corner loads.

Compatibility with Project 4X PRO EP

The Serpent SER401794 is matched to the Project 4X PRO EP layout and supports a tighter connection between the topdeck and the lower chassis. This can lead to steadier mid-corner balance and more repeatable lap times.

Tips for Accurate Installation

Before fitting, check mounting points and clear any debris. Fit the bushing evenly and torque fasteners in stages to avoid uneven pressure that could introduce binding or misalignment.

Is this a direct replacement part?

The SER401794 is intended as a direct-fit upgrade for the Project 4X PRO EP topdeck interface. Verify fitment on your chassis before final assembly.

Will it change handling dramatically?

It offers a subtle but useful reduction in topdeck flex which translates into cleaner responses from the steering, rather than a dramatic handling overhaul.

How should I maintain it?

Keep the bushing and surrounding areas free of grit and inspect for wear during routine service. Replace if the fit starts to feel loose or inconsistent.

Any track setup changes after fitting?

After fitting, run a brief test session and tweak toe or roll centre settings if needed to fine tune handling with the firmer topdeck connection.

Copyright © 2008-2025 rcjaz.com.au All rights reserved