Serpent SER401865 Precision Stiffener Front/Rear Mount X20  [SER401865]

Serpent SER401865 Stiffner Front/Rear mount X20
Price:
AUD$27.55
Brand:
Serpent
Model:
SER401865
Condition:
Brand New
Write a review

Stiffen Your Medius X20 with Serpent SER401865

The Serpent SER401865 front/rear stiffener is a purpose-built part for the Medius X20 MID 1/10 EP series. It adds structural support to the chassis, helping to reduce flex and deliver steadier handling through corners.

Compatibility Notes

Designed for the Medius X20 MID carbon 1/10 EP models, the stiffener reinforces both front and rear mounting points. It is suitable for drivers wanting a firmer platform without changing major suspension parts.

Quick Fit Guide

To install, clean the mount areas, position the stiffener, and tighten the fixings evenly. Check that threads and fasteners are in good order to avoid stripping during installation.

Is this compatible with aftermarket mount kits?

Compatibility depends on whether aftermarket mounts keep the original mounting layout. Verify hole spacing before fitting to avoid interference.

Will it work for off road use?

The stiffener increases chassis rigidity, which can help on smooth tracks; on very rough surfaces you may need to adjust suspension to retain traction.

Maintenance recommendations?

Periodically inspect the mounting faces and re-torque screws after initial runs. Replace any damaged screws or worn mounting hardware for consistent performance.

Does weight increase significantly?

The stiffener adds only a small amount of mass relative to the chassis; its main effect is stiffness rather than notable weight change.

Copyright © 2008-2025 rcjaz.com.au All rights reserved