Serpent SER401871 Dual Shocktower Stiffener Set for X20  [SER401871]

Serpent SER401871 Shocktower stiffner set Front/Rear X20
Price:
AUD$39.08
Brand:
Serpent
Model:
SER401871
Condition:
Brand New
Write a review

Reduce Flex on Your X20 Chassis with SER401871

Upgrade the Serpent Medius X20 MID 1/10 EP by adding the Serpent SER401871 front/rear shocktower stiffener set. The parts reinforce the tower area to limit flex and help the suspension act more consistently under cornering loads.

Performance Advantages

Adding stiffeners improves the distribution of forces around the shock mount area, which tends to reduce unpredictable body roll and improves turn-in. Drivers will notice a firmer, more controlled feel through both slow and high speed sections.

Installation Advice

Installation is a routine job requiring basic hand tools. Remove shocks, fit the stiffener plates, then refit and torque hardware evenly. Reinspect the assembly after the first outings to ensure everything remains secure.

Can I run these with my existing shock towers?

They are intended for the Serpent Medius X20 MID tower geometry. If your towers are stock or equivalent, they should fit; check hole alignment to be sure.

Will these stiffeners change corner balance?

Stiffening the towers can shift chassis balance slightly. Fine tuning anti-roll bars or shock settings may be needed to restore preferred handling characteristics.

Any tips to avoid stripping screws?

Use the correct driver size and tighten incrementally. Avoid excessive force and consider using a small amount of thread locker for racing to prevent loosening.

Copyright © 2008-2025 rcjaz.com.au All rights reserved